REAR DOOR LOCK > INSPECTION |
| 1. INSPECT REAR DOOR LOCK ASSEMBLY LH |
![]() |
Apply the battery voltage to the door lock motor and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locked |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 If the result is not as specified, replace the door lock assembly. | Unlocked |
Measure the resistance of the door lock position switch.
| Tester Connection | Measurement Condition | Door Lock Condition | Specified Condition |
| 6 - 9 | Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locked | 10 kΩ or higher |
| 6 - 9 | Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlocked | Below 1 Ω |
| 2. INSPECT REAR DOOR LOCK ASSEMBLY RH |
![]() |
Apply the battery voltage to the door lock motor and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locked |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlocked |
Measure the resistance of the door lock position switch.
| Tester Connection | Measurement Condition | Door Lock Condition | Specified Condition |
| 6 - 9 | Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locked | 10 kΩ or higher |
| 6 - 9 | Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlocked | Below 1 Ω |