Home › BODY ELECTRICAL › LIGHTING › BACK DOOR COURTESY SWITCH

BACK DOOR COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)


    B164421E08
  1. Check the operation of the back door courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 3
      Lock
      10 kΩ or higher
      Unlock
      Below 1 Ω

      If the result is not specified, replace the back door lock assembly.



2. INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)


  1. Check the operation of the back door courtesy switch.


    E151699E01


    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Door Lock Latch Position
      Specified Condition
      3 - 4
      Open-latch
      Below 1 Ω
      Half-latch
      Below 1 Ω
      Full-latch
      10 kΩ or higher
      Over-latch
      10 kΩ or higher

      If the result is not specified, replace the back door lock assembly.