Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Video Terminal and Television Display

for Preparation Click here


DESCRIPTION

This is the sound signal circuit from the video terminal to the television display assembly.

WIRING DIAGRAM


E153365E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO TERMINAL)


    E152626E01
  1. Disconnect the television display assembly connector.

  1. Disconnect the video terminal connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q13-7 (AUXR) - O25-1 (VAR+)
    Always
    Below 1 Ω
    Q13-8 (AUXL) - O25-2 (VAL+)
    Always
    Below 1 Ω
    Q13-23 (SG7) - O25-3 (VA-)
    Always
    Below 1 Ω
    Q13-24 (OPEN) - O25-8 (ADPG)
    Always
    Below 1 Ω
    Q13-7 (AUXR) - Body ground
    Always
    10 kΩ or higher
    Q13-8 (AUXL) - Body ground
    Always
    10 kΩ or higher
    Q13-23 (SG7) - Body ground
    Always
    10 kΩ or higher
    Q13-24 (OPEN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT VIDEO TERMINAL


    E110048E13
  1. Using an oscilloscope, check the signal waveform between each terminal and body ground according to the conditions shown in the table below.

    Standard conditions:
    Tester Connection
    Condition
    Specified Condition
    O25-1 (VAR+) - Body ground
    External device system is playing, sound is being produced
    Waveform synchronized with sound is output
    O25-2 (VAL+) - Body ground
    External device system is playing, sound is being produced
    Waveform synchronized with sound is output



NG
REPLACE VIDEO TERMINAL
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)