REAR VIEW MONITOR SYSTEM (w/ Navigation System) > Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ASSEMBLY) |
![]() |
Disconnect navigation receiver assembly connector E4.
![]() |
Disconnect television camera assembly connector S1.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S1-2 (CV+) - E4-22 (V+) | Always | Below 1 Ω |
| S1-4 (CB+) - E4-24 (CA+) | Always | Below 1 Ω |
| S1-3 (CGND) - E4-21 (CGND) | Always | Below 1 Ω |
| S1-1 (CV-) - E4-23 (V-) | Always | Below 1 Ω |
| S1-2 (CV+) - Body ground | Always | 10 kΩ or higher |
| S1-4 (CB+) - Body ground | Always | 10 kΩ or higher |
| S1-3 (CGND) - Body ground | Always | 10 kΩ or higher |
| S1-1 (CV-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Reconnect navigation receiver assembly connector E4.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E4-24 (CA+) - E4-21 (CGND) | Ignition switch on (IG) Shift lever R position | Approx. 6 V |
|
| ||||
| OK | |
| 3.INSPECT TELEVISION CAMERA ASSEMBLY |
Reconnect navigation receiver assembly connector E4 and television camera assembly connector S1.

Check the waveform of the television camera assembly using an oscilloscope.
| Item | Content |
| Terminal No. (Symbols) | S1-2 (CV+) - S1-1 (CV-) |
| Tool | 0.2 V/DIV., 0.2 μsec./DIV. |
| Condition | Ignition switch on (IG), shift lever R position |
|
| ||||
| OK | ||
| ||