Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Display Signal Circuit between Clock Assembly and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit of the television camera assembly.

WIRING DIAGRAM


E150790E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - TELEVISION CAMERA ASSEMBLY)


    E146936E05
  1. Disconnect clock assembly connector E11.



    E150736E08
  1. Disconnect television camera assembly connector S1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S1-2 (CV+) - E11-14 (V+)
    Always
    Below 1 Ω
    S1-3 (CGND) - E11-4 (CGND)
    Always
    Below 1 Ω
    S1-4 (CB+) - E11-12 (CA+)
    Always
    Below 1 Ω
    S1-1 (CV-) - E11-15 (V-)
    Always
    Below 1 Ω
    S1-2 (CV+) - Body ground
    Always
    10 kΩ or higher
    S1-3 (CGND) - Body ground
    Always
    10 kΩ or higher
    S1-4 (CB+) - Body ground
    Always
    10 kΩ or higher
    S1-1 (CV-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT CLOCK ASSEMBLY


    E153724E01
  1. Reconnect clock assembly connector E11.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E11-12 (CA+) - E11-4 (CGND)
    Ignition switch on (IG)
    Shift lever R position
    Approx. 6 V



NG
REPLACE CLOCK ASSEMBLY (Click here)
OK


3.INSPECT TELEVISION CAMERA ASSEMBLY


  1. Reconnect clock assembly connector E11 and television camera assembly connector S1.


    E150777E01

  1. Check the waveform of the television camera assembly using an oscilloscope.

    OK:
    Pulses as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    S1-2 (CV+) - S1-1 (CV-)
    Tool
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch on (IG), Shift lever R position



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)