Home › ENGINE › 2GR-FE COOLING › COOLING FAN MOTOR

COOLING FAN MOTOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK NO. 1 COOLING FAN MOTOR


    A169419
  1. Disconnect the No. 1 fan connector.

  1. Connect the battery and an ammeter to the No. 1 fan motor connector.

  1. Check that the No. 1 fan rotates smoothly, and then check the reading on the ammeter.

    Standard current:
    Condition
    Specified Condition
    w/o Trailer Towing System
    6.8 to 9.8 A at 12 V
    w/ Trailer Towing System
    14.6 to 18.7 A at 12 V

    HINT:
    1. Refer to the indication mark illustration for the indication mark location.
    2. If the result is not as specified, replace the No. 1 cooling fan motor.

  1. Reconnect the No. 1 fan motor connector.



2. CHECK NO. 2 COOLING FAN MOTOR


    A169420
  1. Disconnect the No. 2 fan connector.

  1. Connect the battery and an ammeter to the No. 2 fan motor connector.

  1. Check that the No. 2 fan rotates smoothly, and then check the reading on the ammeter.

    Standard current:
    Condition
    Specified Condition
    w/o Trailer Towing System
    6.8 to 9.8 A at 12 V
    w/ Trailer Towing System
    14.6 to 18.7 A at 12 V

    1. Refer to the indication mark illustration for the indication mark location.
    2. If the result is not as specified, replace the No. 2 cooling fan motor.

  1. Reconnect the No. 2 fan motor connector.