Home › BODY ELECTRICAL › HORN › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY (w/ Microphone)
  1. Disconnect steering pad switch assembly connector A from the steering pad.



  1. Disconnect steering pad switch assembly connector B from the spiral cable.


    E151678E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:

    Tester connection
    Condition
    Specified condition
    A-1 - B-1 (HO)
    Always
    Below 1 Ω

    If the result is not as specified, replace the steering pad switch assembly.



2. INSPECT STEERING PAD SWITCH LH (w/o Microphone)
  1. Disconnect steering pad switch LH connector A from the steering pad.



  1. Disconnect steering pad switch LH connector B from the spiral cable.


    E160935E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester connection
    Condition
    Specified condition
    A-1 - B-1 (HO)
    Always
    Below 1 Ω

    If the result is not as specified, replace the steering pad switch LH.