Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter sends an external device sound signal to the navigation receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, navigation receiver assembly, or speakers.

WIRING DIAGRAM


E168523E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO JACK ADAPTER)


    E150770E02
  1. Disconnect stereo jack adapter connector E12 and navigation receiver assembly connector E6.



    E150781E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E12-4 (AUXO) - E6-6 (ADPG)
    Always
    Below 1 Ω
    E12-3 (ASGN) - E6-5 (VA-)
    Always
    Below 1 Ω
    E12-2 (ARO) - E6-2 (VAR+)
    Always
    Below 1 Ω
    E12-1 (ALO) - E6-3 (VAL+)
    Always
    Below 1 Ω
    E12-4 (AUXO) - Body ground
    Always
    10 kΩ or higher
    E12-3 (ASGN) - Body ground
    Always
    10 kΩ or higher
    E12-2 (ARO) - Body ground
    Always
    10 kΩ or higher
    E12-1 (ALO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)