Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly

for Preparation Click here


DESCRIPTION

The navigation receiver assembly controls the volume according to the MUTE signal from the television display assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode, etc. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the navigation receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM


E152225E02


INSPECTION PROCEDURE

1.INSPECT TELEVISION DISPLAY ASSEMBLY


    E153728E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q13-26 (LMUT) - Body ground
    Turn ignition switch on (ACC), RSE system is playing → Changing mode
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION DISPLAY ASSEMBLY)


    E150773E02
  1. Disconnect navigation receiver assembly connector E15 and television display assembly connector Q13.



    E126469E15
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-6 (MUTE) - Q13-26 (LMUT)
    Always
    Below 1 Ω
    E15-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEVISION DISPLAY ASSEMBLY
  1. Replace the television display assembly and check if it operates normally (Click here).

    OK:
    The navigation system operates normally.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

NORMAL OPERATION