REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL ENGINE REAR OIL SEAL |
![]() |
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal.
| 2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
![]() |
Apply adhesive to 2 or 3 threads of the mounting bolt end.
![]() |
Install the front spacer, drive plate and rear spacer on the crankshaft.
Install and tighten the 8 mounting bolts uniformly in several steps.
| 3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD) |
| 4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 4WD) |