SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Check for the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Erase the DTCs.
| CLEAR DTC (Without using the Techstream) |
Perform either one of the following operations:
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI No. 1 and ETCS fuses from the relay block located inside the engine compartment for more than 1 minute.