SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
Check and ensure the following conditions:
Battery voltage 12 V or more
Throttle valve fully closed
The shift lever in the P or N position
A/C switched OFF
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure that the MIL flashes as shown in the illustration.
Start the engine.
Make sure that the MIL goes off.
Simulate the conditions of the malfunction described by the customer.
Check for DTCs and freeze frame data using the tester.