Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTCs
Components
Fail-Safe Operations
Fail-Safe Deactivation Conditions
P0031, P0032, P0051 and P0052
Air fuel ratio sensor heater
ECM turns off air fuel ratio sensor heater
Ignition switch off
P0037, P0038, P0057 and P0058
Heated oxygen sensor heater
ECM turns off heated oxygen sensor heater
Ignition switch off
P0100, P0102 and P0103
Mass air flow meter
ECM calculates ignition timing according to engine speed and throttle valve position
Pass condition detected
P0110, P0112 and P0113
Intake air temperature sensor
ECM estimates Intake air temperature to be 20°C (68°F)
Pass condition detected
P0115, P0117 and P0118
Engine coolant temperature sensor
ECM estimates engine coolant temperature sensor to be 80°C (176°F)
Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
Electronic throttle control system
ECM cuts off throttle actuator current and throttle valve returned to 6° throttle position by return spring
ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle, to allow vehicle to continue at minimal speed*1
Pass condition detected and then ignition switch turned off
P0300, P0301, P0302, P0303, P0304, P0305 and P0306*2
  1. Fuel injector
  2. Electronic throttle control system
When misfire occurs, fuel cut is performed for catalyst overheat malfunction prevention
  1. During normal load and normal engine speed (MIL is blinking)
    - Fuel cut is performed on malfunctioning cylinder
  1. During high load and high engine speed (MIL is blinking)
    - Throttle valve opening angle control is performed
    - All cylinder fuel cut or malfunction cylinder fuel cut
Pass condition detected and then ignition switch turned off
P0327, P0328, P0332 and P0333
Knock Sensor
ECM sets ignition timing to maximum retard
Ignition switch off
P0351 to P0356
Igniter
ECM cuts fuel
Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
Accelerator pedal position sensor
Accelerator pedal position sensor has 2 sensor circuits: Main and Sub
If either of circuits malfunctions, ECM controls engine using the other circuit
If both of circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles
Pass condition detected and then ignition switch turned off

HINT:
  1. *1: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.
  2. *2: Misfire related fail-safe operations occur when catalyst overheat malfunctions occur.