DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | Open in electronic throttle control system power source (+BM) circuit (1 trip detection logic) |
|
| Related DTCs | P2118: Throttle actuator power supply |
| Required Sensors / Components (Main) | Throttle actuator, throttle valve, electronic throttle control system fuse |
| Required Sensors / Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | 0.8 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Battery voltage | 8 V or more |
| Throttle actuator power | ON |
| Throttle actuator power supply voltage (+BM) | Less than 4 V |
| Throttle actuator power supply voltage | 9 to 14 V |

| 1.CHECK FUSE (ETCS FUSE) |
![]() |
Remove the ETCS fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ETCS fuse | Always | Below 1 Ω |
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 2.INSPECT ECM (+BM VOLTAGE) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D35-7 (+BM) - B3-1 (E1) | Ignition switch on (IG) | 9 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room relay block.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| ETCS fuse (2) - D35-7 (+BM) | Below 1 Ω |
| Tester Connection | Specified Condition |
| ETCS fuse (2) or D35-7 (+BM) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the ETCS fuse.
|
| ||||
| OK | ||
| ||