FRONT BRAKE > INSPECTION |
| 1. INSPECT PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| 2. INSPECT DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| 3. INSPECT BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust or scoring. If necessary, replace the disc brake cylinder assembly and piston.
| 4. INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE |
Inspect the front disc brake pad support plate. If necessary, replace the front brake pad support plate.
| 5. INSPECT DISC RUNOUT |
![]() |
Using SST to hold the disc, tighten the disc with the 5 hub nuts.
![]() |
Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.
Remove the 5 hub nuts and the front disc.