WINDSHIELD DEICER SWITCH > ON-VEHICLE INSPECTION |
| 1. CHECK WINDSHIELD DEICER SWITCH |
Disconnect the windshield deicer switch connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (ILL+) - 7 (ILL-) | Headlight dimmer switch OFF → ON | Below 1 V → 11 to 14 V |
| 10 (D) - 9(E) | Ignition switch on (IG) | 11 to 14 V |
| 6 (IG) - 9(E) | Ignition switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| 7 (ILL-) - Body ground | Always | Below 1 Ω |
| 9 (E) - Body ground | Always | Below 1 Ω |
Reconnect the windshield deicer connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 10 (D) - 9 (E) | Ignition switch on (IG) , windshield deicer switch OFF → ON | 11 to 14 V → Below 1 V (after 15 + / - 3 minutes: 11 to 14 V) |
| 6 (IG) - 9 (E) | Ignition switch on (IG) , windshield deicer switch OFF → ON | Below 1 V → 11 to 14 V |
![]() |
Check the ON/OFF indicator of the switch.
Push the switch several times. Check that the ON/OFF indicator illuminates or turns off according to the switch operation.
![]() |
Check the illumination area of the switch.
Check that the ON/OFF indicator illuminates or turns off according to the switch operation.