BACK DOOR CLOSER SYSTEM > TERMINALS OF ECU |
| CHECK POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) |

Disconnect the O15 ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| O15-12 (B) - Body ground | B - Body ground | Battery power supply | Always | 10 to 14 V |
| O15-10 (ECUB) - Body ground | BR - Body ground | ECUB power supply | Always | 10 to 14 V |
| O15-8 (IG) - Body ground | GR - Body ground | IG power supply | Ignition switch on (IG) | 10 to 14 V |
| O15-8 (IG) - Body ground | GR - Body ground | IG power supply | Ignition switch off | Below 1 V |
| O15-11 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the O15 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| O15-2 (DC+) - O15-1 (DC-) | B - G | Back door lock motor circuit | Back door lock motor is operating | 10 to 14 V |
| O15-2 (DC+) - O15-1 (DC-) | B - G | Back door lock motor circuit | Back door lock motor is not operating | Below 1 V |
| O15-20 (FUL) - Body ground | LG - Body ground | Back door courtesy switch circuit | Back door is closed | 10 to 14 V |
| O15-20 (FUL) - Body ground | LG - Body ground | Back door courtesy switch circuit | Back door is open | Below 1 V |
| O15-22 (HAF) - Body ground | R - Body ground | Back door lock half-latch switch signal circuit | Back door is open → Back door closer motor → Back door is closed | Below 1 V → 10 to 14 V → Below 1 V |
| O15-24 (POS) - Body ground | LG - Body ground | Back door lock position switch signal circuit | Back door is open → Back door closer operates → Back door is closed | Below 1 V → 10 to 14 V → Below 1 V |
| CHECK MAIN BODY ECU |

Disconnect the D7, D8, 1F and 1M connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| D8-26 (BDSU) - Body ground | Y - Body ground | Back door open switch signal circuit | Back door open switch ON | Below 1 Ω |
| D8-26 (BDSU) - Body ground | Y - Body ground | Back door open switch signal circuit | Back door open switch OFF | 10 kΩ or higher |
| D7-2 (PBDS) - Body ground* | R - Body ground | Power back door open / close switch signal circuit | Power back door open / close switch ON | Below 1 Ω |
| D7-2 (PBDS) - Body ground* | R - Body ground | Power back door open / close switch signal circuit | Power back door open / close switch OFF | 10 kΩ or higher |
| 1F-10 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 1M-9 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |