Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using Techstream to read the Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Enter the following menus: Body Electrical / Main Body or Smart Key / Data List.

  4. Read the Data List according to the display on the tester.

    Main Body (Main body ECU):  
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Wireless Control
    Wireless door lock control function / ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Hazard Answer Back
    Hazard answer-back of wireless / ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Wireless Auto Lock
    Wireless door lock control function / ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Open Door Warning
    Open door warning / ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Unlock 2 Operation
    Unlock 2 Operation of wireless unlock / ON or OFF
    ON: All doors unlock when UNLOCK switch pressed twice
    OFF: All doors unlock when UNLOCK switch pressed once
    -
    Auto Lock Time
    Automatic lock time / 120 s, 60 s or 30 s
    120 s: 120 seconds
    60 s: 60 seconds
    30 s: 30 seconds
    -
    Wireless Buzzer Resp
    Wireless door lock buzzer response / ON or OFF
    ON: Operating
    OFF: Not operating
    -

    Smart Key (Certification ECU (Smart Key ECU Assembly)):  
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Panic Alarm Function
    Panic function / ON or OFF
    ON: Operating
    OFF: Not operating
    -


ACTIVE TEST

HINT:
Using Techstream to perform Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Test early in troubleshooting is one way to save diagnostic time. The Data List can be displayed during the Active Test.

  1. Connect Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Enter the following menus: Body Electrical / Main Body or Smart Key / Active Test.

  4. Perform the Active Test according to the display on the tester.

    Main Body (Main body ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turn signal flasher relay
    ON/OFF
    Observe headlight and rear combination light for correct operation
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -
    Illuminated Entry System
    Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed)
    ON/OFF
    -
    Trunk and Back-Door Open
    Back door opener motor
    ON/OFF
    Observe back door

    Smart Key (Certification ECU (Smart Key ECU Assembly)): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Wireless Buzzer Operation
    Wireless door lock buzzer
    ON/OFF
    -