Home › BODY › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Body Electrical / Back Door or Main Body / Data List /

  5. According to the display on the tester, read the "Data List".

    Back Door (Power back door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Door Lock Status
    Back door lock condition signal / LOCK or UNLOCK
    LOCK: Back door is locked
    UNLOCK: Back door is unlocked
    -
    Closer Position SW
    Closer position switch signal / ON or OFF
    ON: Back door lock center gear is center position
    OFF: Back door lock center gear is not in center position
    -
    Courtesy SW
    Back door courtesy switch signal / ON or OFF
    ON: Back door is open
    OFF: Back door is closed
    -
    Half Latch SW
    Half-latch switch signal / ON or OFF
    ON: Back door lock motor is open-latch or over-latch
    OFF: Back door lock motor is full-latch or half-latch
    -

    Main Body (Main body ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    B Dor Handle
    Back door open switch signal / ON or OFF
    ON: Back door open switch is ON
    OFF: Back door open switch is OFF
    -


ACTIVE TEST

HINT:
Using Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.

  1. Connect Techstream to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Body Electrical / Back Door / Active Test /

  5. According to the display on the tester, perform the "Active Test".

    Back Door (Power back door ECU) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    PBD Motor
    Power back door motor
    ON / OFF
    -
    Latch Release
    Power back door motor
    ON / OFF
    -