Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/o Smart Key System)

THEFT DETERRENT SYSTEM (w/o Smart Key System) > Ignition Switch Circuit


DESCRIPTION

The main body ECU determines the ignition switch position (OFF, ACC, ON) based on signals from the IG or ACC circuit.

WIRING DIAGRAM


B154254E04


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn Techstream main switch on.

  1. Select the items below in the Data List and read the display on Techstream.

    Main Body: 
    Item
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch ON signal ON/OFF
    ON: Ignition switch is in the ON position
    OFF: Ignition switch OFF
    -
    ACC SW
    Ignition switch ACC signal ON/OFF
    ON: Ignition switch is in the ACC position
    OFF: Ignition switch is OFF
    -

    OK:
    When the ignition switch is operated, the display changes as shown in the table.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK)


    B154257E03
  1. Disconnect the 1A junction block connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1A-1 - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT IGNITION SWITCH ASSEMBLY


    B125076E03
  1. Disconnect the D24 ignition switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Ignition switch ON
    Below 1 Ω
    2 - 4
    Ignition switch ACC
    Below 1 Ω



NG
REPLACE IGNITION SWITCH ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B - INSTRUMENT PANEL J/B)


    B154258E03
  1. Disconnect the 1I junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1I-4 - 1I-9
    Ignition switch ON
    Below 1 Ω
    1I-4 - 1I-3
    Ignition switch ACC
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND)


    B164981E03
  1. Disconnect the 1F junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1F-10 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)