Home › BODY ELECTRICAL › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B159681E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch free (Key removed)
    10 kΩ or higher
    1 - 2
    Switch pushed (Key set)
    Below 1 Ω

    If the result is not as specified, replace the unlock warning switch assembly.