BLOWER MOTOR CONTROLLER (for Rear) > REMOVAL |
| 1. REMOVE REAR DOOR SCUFF PLATE RH |
| 2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 3. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board assembly.
| 4. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY |
![]() |
Disengage the 2 guides and remove the No. 3 deck board sub-assembly.
| 5. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY |
![]() |
Disengage the 2 guides and remove the No. 2 deck board sub-assembly.
| 6. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Remove the tonneau cover assembly.
| 7. REMOVE REAR SEAT SIDE COVER LH |
![]() |
Disengage the 2 clips and remove the rear seat side cover LH.
| 8. REMOVE DECK SIDE TRIM BOX LH |
![]() |
Remove the 2 deck side trim clips and clip.
Remove the deck side trim box LH as shown in the illustration.

| 9. REMOVE REAR SEAT SIDE COVER RH |
![]() |
Disengage the 2 clips and remove the rear seat side cover RH.
| 10. REMOVE JACK CARRIER SUPPORT |
| 11. REMOVE JACK CARRIER CUSHION |
![]() |
Remove the jack carrier cushion.
| 12. REMOVE JACK ASSEMBLY |
![]() |
Remove the jack assembly.
| 13. REMOVE JACK CARRIER ASSEMBLY |
![]() |
Using a screwdriver, disengage the 3 claws and remove the jack carrier assembly.
| 14. REMOVE DECK SIDE TRIM BOX RH |
![]() |
Remove the 2 deck side trim clips and clip.
Remove the deck side trim box RH as shown in the illustration.

| 15. REMOVE REAR MAT |
![]() |
Remove the rear mat.
| 16. REMOVE DECK FLOOR BOARD ASSEMBLY |
![]() |
Disengage the 3 claws.
Remove the 2 nuts and the deck floor board assembly.
| 17. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY |
![]() |
Remove the bolt and rear No. 2 seat inner belt assembly.
| 18. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH |
![]() |
Remove the bolt and disconnect the rear seat lap type belt assembly LH.
| 19. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH |
| 20. REMOVE REAR NO. 2 SEAT ASSEMBLY |
![]() |
Remove the 4 bolts and the rear No. 2 seat assembly.
| 21. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Disengage the 4 clips and the 4 claws, and remove the rear floor finish plate.
| 22. REMOVE REAR SEAT SIDE GARNISH CAP |
![]() |
Remove the screw.
Disengage the 6 claws and the guide, and remove the rear seat side garnish cap.
| 23. REMOVE DECK SIDE TRIM COVER RH |
| 24. REMOVE DECK SIDE TRIM RH |
| 25. REMOVE SIDE TRIM COVER RH (for Manual Air Conditioning System) |
![]() |
Disengage the 4 claws and remove the side trim cover RH.
| 26. REMOVE REAR ROOM TEMPERATURE SENSOR (for Automatic Air Conditioning System) |
![]() |
Disengage the 4 claws and remove the rear room temperature sensor.
Disconnect the connector.
| 27. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH |
![]() |
Using a screwdriver, disengage the 6 claws and the 2 guides, and remove the rear combination light service cover RH.
| 28. REMOVE ROPE HOOK ASSEMBLY (for RH Side) |
| 29. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
| 30. REMOVE FRONT DECK SIDE TRIM COVER RH |
| 31. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
Remove the 3 bolts.
Remove the 2 clips.
Disengage the 7 claws and 4 clips, and remove the deck trim side panel assembly RH.

| 32. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH |
| 33. REMOVE BLOWER MOTOR CONTROLLER |
![]() |
Disconnect the connector.
Remove the 2 screws and the blower motor controller.