REAR COOLING UNIT > REASSEMBLY |
| 1. INSTALL REAR EVAPORATOR TEMPERATURE SENSOR |
![]() |
Engage the claw and install the rear evaporator temperature sensor.
Engage the clamp to the rear cooling unit.
| 2. INSTALL REAR EVAPORATOR SUB-ASSEMBLY |
![]() |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the rear evaporator sub-assembly.
![]() |
Install the rear evaporator sub-assembly as shown in the illustration.
![]() |
Install the 12 screws.
| 3. INSTALL REAR COOLING UNIT EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, install the rear cooling unit expansion valve with the 2 hexagon bolts.
![]() |
Install the grommet.
![]() |
Engage the 3 claws and install the plate.
| 4. INSTALL BLOWER MOTOR CONTROLLER |
![]() |
Install the blower motor controller with the 2 screws.
| 5. INSTALL REAR BLOWER MOTOR SUB-ASSEMBLY |
![]() |
Install the rear blower motor sub-assembly with the 3 screws.
| 6. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Install the heater radiator unit sub-assembly as shown in the illustration.
![]() |
Install the clamp with the screw.
| 7. INSTALL HEATER WATER PIPE AND HOSE SUB-ASSEMBLY |
Install the screw <A>.
Install the heater water pipe and hose sub-assembly with the screw <B>.
Using pliers, grip the claws of the 2 clips and slide the clips to connect the heater water hose.

| 8. INSTALL REAR AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces of the rear air conditioning tube and accessory assembly.
![]() |
Install the 2 new O-rings on the rear air conditioning tube and accessory assembly.
![]() |
Move the hook connector in the direction indicated by the arrow in the illustration.
Insert the pipe joint into the fitting hole securely and tighten the bolt.
![]() |
Install the bolt <A>.
Install the screw <B>.
Install the rear air conditioning tube and accessory assembly with the screw <C>.
![]() |
Install the packing.
| 9. INSTALL REAR AIR OUTLET CONTROL SERVO MOTOR SUB-ASSEMBLY |
![]() |
Using the reference point, install the rear air outlet control servo motor sub-assembly with the 2 screws.
Connect the connector.
| 10. INSTALL REAR AIR MIX CONTROL SERVO MOTOR SUB-ASSEMBLY |
![]() |
Using the reference point, install the rear air mix control servo motor sub-assembly with the 2 screws.
Connect the connector.
| 11. INSTALL DRAIN COOLER HOSE |
![]() |
Using the reference point, install the drain cooler hose.