POWER BACK DOOR SYSTEM > Touch Sensor Circuit |

| 1.READ VALUE USING TECHSTREAM (POWER BACK DOOR TOUCH SENSOR) |
Check the Data List for proper functioning of the power back door touch sensor.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PBD Touch Sen L | Power back door touch sensor LH signal / ON or OFF | ON: Power back door touch sensor LH is pressed OFF: Power back door touch sensor LH is not pressed | - |
| PBD Touch Sen R | Power back door touch sensor RH signal / ON or OFF | ON: Power back door touch sensor RH is pressed OFF: Power back door touch sensor RH is not pressed | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT POWER BACK DOOR TOUCH SENSOR |
![]() |
Remove the power back door touch sensor. (Click here)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Not pressed | Approx. 1 kΩ |
| 1 - 2 | Pressed | Below 100 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER BACK DOOR TOUCH SENSOR - POWER BACK DOOR DRIVE UNIT AND BODY GROUND) |
![]() |
LH Side
Disconnect the T7 sensor connectors.
Disconnect the O15 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T7-1 (OSL) - O15-15 (OSL) | Always | Below 1 Ω |
| T7-2 (OSLE) - O15-14 (OSE) | Always | Below 1 Ω |
| T7-1 (OSL) - Body ground | Always | 10 kΩ or higher |
| T7-2 (OSLE) - Body ground | Always | Below 1 Ω |
![]() |
RH Side
Disconnect the T8 sensor connectors.
Disconnect the O15 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T8-1 (OSR) - O15-13 (OSR) | Always | Below 1 Ω |
| T8-2 (OSRE) - O15-14 (OSE) | Always | Below 1 Ω |
| T8-1 (OSR) - Body ground | Always | 10 kΩ or higher |
| T8-2 (OSRE) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||