POWER BACK DOOR SYSTEM > CUSTOMIZE PARAMETERS |
| CUSTOMIZE |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus:
Select: Customize Setting /
Select the setting by referring to the table below.
| Display (Item) | Default | Function | Setting |
| PBD SW Operation | 0.8 s | Function that turns power back door closer switch ON when switch is pushed once or held down for 0.8 sec. | 0.8s / ON |
| PBD Buzzer | ON | This function makes the power back door buzzer sound when power back door is operating | ON / OFF |
| Wirels PBD SW Operation | 0.8 s | Function that operates power back door when transmitter switch is pressed in specified way | ON / 2 times / 0.8 s / OFF |