Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH

COMPRESSOR AND MAGNETIC CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)


    E152688E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B45-2 (SSR+) - B45-5 (SSR-)
    20°C (68°F)
    165 to 320 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.



2. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)


    E152688E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B45-3 (SOL+) - B45-6 (SOL-)
    25°C (77°F)
    10.1 to 11.1 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.



3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH


    E152688E05
  1. Disconnect the connector from the compressor and magnetic clutch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B45-1 (MG+) - Body Ground
    Always
    Below 1 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.