Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Rear Air Conditioning Control Panel Circuit

for Preparation Click here


DESCRIPTION

This circuit consists of the rear air conditioning control and the air conditioning amplifier. When the rear air conditioning control is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the rear air conditioning control is operated.

WIRING DIAGRAM


E153882E08


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING CONTROL - BODY GROUND)


    E152690E13
  1. Disconnect the R1 rear air conditioning control connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    R1-10 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING CONTROL - BATTERY)


    E152690E14
  1. Disconnect the R1 rear air conditioning control connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    R1-10 (E) - R1-2 (IG+)
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - REAR AIR CONDITIONING CONTROL)


    E153374E11
  1. Disconnect the R1 control connector.

  1. Disconnect the D38 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D38-13 (RLIN) - R1-5 (MPX-)
    Always
    Below 1 Ω
    D38-13 (RLIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE REAR AIR CONDITIONING CONTROL
  1. Replace the rear air conditioning control .


NEXT


5.CHECK REAR AIR CONDITIONING CONTROL (OPERATION)
  1. Operate the rear air conditioning control to check that it functions properly.

    OK:
    Rear air conditioning control function operates normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER
OK

END (REAR AIR CONDITIONING CONTROL IS DEFECTIVE)