Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone to the radio receiver.
It also supplies power from the radio receiver to the microphone.

WIRING DIAGRAM


E153638E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E151939E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E14-7 (MCVD) - Body ground
    Ignition switch on (ACC)
    4 to 6 V



NG
REPLACE RADIO RECEIVER
OK


2.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER)


    E151940E02
  1. Disconnect the microphone connector and the radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q11-1 (ACC) - E14-7 (MCVD)
    Always
    Below 1 Ω
    Q11-3 (MI1+) - E14-2 (MIC+)
    Always
    Below 1 Ω
    Q11-5 (MIC-) - E14-1 (MIC-)
    Always
    Below 1 Ω
    E14-3 (TSW-) - E14-6 (MGND)
    Always
    Below 1 Ω
    Q11-1 (ACC) - Body ground
    Always
    10 kΩ or higher
    Q11-3 (MI1+) - Body ground
    Always
    10 kΩ or higher
    Q11-5 (MIC-) - Body ground
    Always
    10 kΩ or higher
    E14-3 (TSW-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)