Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the ignition switch is turned off. If the output voltage is higher than 7 volts when the ignition switch is turned off, the ECM will illuminate the MIL and set a DTC when the ignition switch on (IG).

DTC
DTC Detection Condition
Trouble Area
P0657
Throttle actuator power supply error
ECM

MONITOR STRATEGY


Related DTC
P0657: ETCS power supply
Required sensors/Components (main)
ECM
Required sensors/Components (sub)
Throttle actuator
Frequency of Operation
Once per driving cycle
Duration
Within 1 second
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever this DTC is not present
None
Ignition switch
From on (IG) to off

TYPICAL MALFUNCTION THRESHOLDS


Throttle actuator power supply
7 V or more

INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0657)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Clear the DTC.

  1. Turn the ignition switch off.

  1. Disconnect the battery negative terminal and wait for 1 minute.

  1. Connect the battery negative terminal.

  1. Turn the ignition switch on (IG) for 10 seconds.

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG).

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    P0657
    A
    No output DTC
    B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A

REPLACE ECM (Click here)