Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C157758E01
  1. Remove the tire pressure warning reset switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D32-1 - D32-2
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the tire pressure warning reset switch.