Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Navigation Receiver Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM


E153686E01


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E150787E01
  1. Disconnect the navigation receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-20 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E2-1 (B) - E2-20 (GND)
    Always
    11 to 14 V
    E2-11 (ACC) - E2-20 (GND)
    Ignition switch on (ACC)
    11 to 14 V
    E5-2 (IG) - E2-20 (GND)
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)