Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The television display assembly sends a mute signal to the radio receiver.
The radio receiver controls the volume according to the MUTE signal from the television display assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode, etc.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM


E175068E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E152226E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E16-6 (MUTE) - Body ground
    Turn ignition switch on (ACC), RSE system is playing → Mode is changing
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY ASSEMBLY)


    E152223E07
  1. Disconnect the radio receiver and the television display assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-6 (MUTE) - Q13-26 (LMUT)
    Always
    Below 1 Ω
    E16-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT TELEVISION DISPLAY ASSEMBLY


    E152224E02
  1. Reconnect the television display assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q13-26 (LMUT) - Body ground
    Turn ignition switch on (ACC)
    Above 3.5 V



NG
REPLACE TELEVISION DISPLAY ASSEMBLY
OK

REPLACE RADIO RECEIVER