Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B173224
  1. Disengage the 8 claws and guide, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B173227
  1. Remove the clip.

  1. Disengage the clip and claw, and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)


    B168371
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 claws and 10 clips.

  1. Disconnect each connector.

  1. Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)


    B173021
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 claws and 10 clips.



    B173009
  1. Disconnect each connector and the aspirator duct.

  1. Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



5. REMOVE BRAKE PEDAL RETURN SPRING


    C165369
  1. Remove the brake pedal return spring from the push rod pin and instrument panel reinforcement.



6. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E150073
  1. Disconnect the connector.



    E150074E01
  1. Loosen the stop light switch lock nut and remove the stop light switch assembly.



7. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Remove the clip and push rod pin, and separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.



8. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    C165371
  1. Disconnect the brake pedal load sensing switch connector and disengage the clamp.



    C165373
  1. Remove the 2 bolts and separate the brake pedal support sub-assembly from the instrument panel reinforcement.



    C165374
  1. Remove the 4 nuts and brake pedal support sub-assembly from the body.