Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > DISASSEMBLY

for Preparation Click here



1. REMOVE BRAKE MASTER CYLINDER TO WAY TUBE


    C165949
  1. Mount the brake master cylinder sub-assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

  1. Using a union nut wrench (12 mm), remove the brake master cylinder to way tube from the No. 2 brake tube way and brake master cylinder body.



2. REMOVE NO. 2 BRAKE TUBE WAY
  1. Remove the No. 2 brake tube way from the brake master cylinder body.



3. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY


    C165948
  1. Mount the brake master cylinder sub-assembly in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

  1. Using a pin punch and a hammer, tap out the straight pin, and remove the brake master cylinder reservoir assembly.



4. REMOVE MASTER CYLINDER RESERVOIR GROMMET
  1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.