BRAKE MASTER CYLINDER > REASSEMBLY |
| 1. INSTALL MASTER CYLINDER RESERVOIR GROMMET |
Apply lithium soap base glycol grease to 2 new master cylinder reservoir grommets.
Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.
| 2. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY |
Install the brake master cylinder reservoir assembly to the master cylinder body.
![]() |
Mount the brake master cylinder sub-assembly in a vise.
Using a pin punch and a hammer, tap in the straight pin.
| 3. INSTALL NO. 2 BRAKE TUBE WAY |
Install the No. 2 brake tube way to the brake master cylinder body.
| 4. INSTALL BRAKE MASTER CYLINDER TO WAY TUBE |
![]() |
Secure the No. 2 brake tube way to the brake master cylinder body with the 2 bolts, 2 nuts and 4 washers as shown in the illustration.
![]() |
Mount the brake master cylinder sub-assembly in a vise.
Using a union nut wrench (12 mm), install the brake master cylinder to way tube to the brake master cylinder body and No. 2 brake tube way.
Remove the 2 bolts, 2 nuts and 4 washers.