LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus.
Techstream - Select: Body Electrical / Body / Main body / Data List /
According to the display on the tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between power window regulator motor (for driver side) and main body ECU / OK or STOP | OK: Connection | DTC is output if an error occurs in LIN communication |
| Communication Slide Roof | Connection status between Sliding Roof ECU and main body ECU / OK or STOP | OK: Connection | DTC is output if an error occurs in LIN communication |
| Communication Smart / Wireless | Connection status between certification ECU and main body ECU / OK or STOP | OK: Connection | DTC is output if an error occurs in LIN communication |