DTC B2287 LIN Communication Master Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2287 | There is an open, short or ECU communication malfunction between main body ECU (instrument panel junction block assembly) and certification ECU (smart key ECU assembly). |
|

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - MAIN BODY ECU) |
Disconnect the D40 connector.
![]() |
Disconnect the 1E connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-10 (LIN) - 1E-7 (LIN1) | Always | Below 1 Ω |
| D40-10 (LIN) or 1E-7 (LIN1) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-10 (LIN) - Body ground | Always | Below 1 V |
|
| ||||
| OK | |
| 2.REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
Replace the main body ECU (instrument panel junction block assembly) with a normally-functioning or a new one.
Delete the DTC.
| NEXT | |
| 3.CHECK FOR DTC |
Recheck for DTC.
| Result | Proceed to |
| B2287 is not output | A |
| B2287 is output | B |
|
| ||||
| A | ||
| ||