Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B2789    No Response from ID BOX

for Preparation Click here


DESCRIPTION

This DTC is output when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B2789
No communication between certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for more than 10 seconds
  1. ID code box (Immobiliser code ECU)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness

WIRING DIAGRAM


B156210E20


INSPECTION PROCEDURE

NOTICE:
When using Techstream with the ignition switch off to troubleshoot:
Connect Techstream to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)


    B162909E03
  1. Disconnect the D40 and D31 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-10 (LIN) - D31-3 (LIN1)
    Always
    Below 1 Ω
    D40-10 (LIN) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D40-10 (LIN) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK ID CODE BOX (IMMOBILISER CODE ECU)


    B177002E01
  1. Disconnect the D31 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D31-8 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-1 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Replace the ID code box (immobiliser code ECU) with a new one.

  1. Delete the DTC.


NEXT


4.CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B2789 is not output
    A
    B2789 is output
    B



B
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
A

END