Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK BUZZER

WIRELESS DOOR LOCK BUZZER > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER ASSEMBLY


2. REMOVE NO. 1 ENGINE UNDER COVER


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



3. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH


    B172795
  1. Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.



    B172796
  1. Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.



    B172797E01
  1. Remove the front fender side protector from the front fender moulding sub-assembly.



4. REMOVE FRONT FENDER LINER LH


    B175996E01
  1. Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    B174749
  1. Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.



    B174751
  1. Remove the 5 clips, 8 screws and front fender liner LH.



5. REMOVE WIRELESS DOOR LOCK BUZZER


    B174118
  1. Disconnect the connector.

  1. Remove the clamp and the wireless door lock buzzer.