Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT HOOD PROTECTOR


    B172908
  1. Disengage the 4 claws and remove the front hood protector.



2. REMOVE RADIATOR SEAL SUB-ASSEMBLY


    B177263
  1. Remove the 6 clips.

  1. Disengage the 2 clips and remove the radiator seal sub-assembly.



3. REMOVE HOOD TO RADIATOR SUPPORT SEAL


    B172907
  1. Remove the 8 clips and hood to radiator support seal.



4. REMOVE HOOD INSULATOR


    B172909
  1. Using a clip remover, remove the 8 clips and the hood insulator.



5. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E147127E01
  1. Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.

    NOTICE:
    Be careful not to damage the windshield.

    HINT:
    Tape the screwdriver tip before use.



    E128831
  1. Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.



6. DISCONNECT WASHER HOSE ASSEMBLY


    B172910
  1. Disconnect the washer hose assembly.