Home › BODY ELECTRICAL › DOOR LOCK › ENTRY LOCK AND UNLOCK SWITCH (for Front Door)

ENTRY LOCK AND UNLOCK SWITCH (for Front Door) > INSPECTION

for Preparation Click here



1. INSPECT ENTRY LOCK SWITCH (for Driver Side)


    B112465E30
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    z13-1 (TRG-) - z13-3 (TRG+)
    Lock switch not pushed
    10 kΩ or higher
    z13-1 (TRG-) - z13-3 (TRG+)
    Lock switch pushed
    Below 1 Ω

    If the result is not specified, replace the entry lock switch.



2. INSPECT ENTRY LOCK SWITCH (for Front Passenger Side)


    B112465E31
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    z15-1 (TRG-) - z15-3 (TRG+)
    Lock switch not pushed
    10 kΩ or higher
    z15-1 (TRG-) - z15-3 (TRG+)
    Lock switch pushed
    Below 1 Ω

    If the result is not specified, replace the entry lock switch.