Home › ENGINE › 2GR-FE STARTING › IGNITION RELAY

IGNITION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IGNITION RELAY


  1. Inspect the No. 1 ignition relay.



      A092673E23
    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage is not applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage is applied to terminals 1 and 2
      Below 1 Ω

      If the resistance is not as specified, replace the No. 1 ignition relay.



  1. Inspect the No. 2 ignition relay.



      B016200
    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage is not applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage is applied to terminals 1 and 2
      Below 1 Ω

      If the resistance is not as specified, replace the No. 2 ignition relay.