Home › ENGINE › 2GR-FE LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A085603E04
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A127994
  1. Using a 24 mm deep socket wrench, install the oil pressure switch. (w/o oil cooler)

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.



    A170011
  1. Using a 24 mm deep socket wrench, install the oil pressure switch. (w/ oil cooler)

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch assembly connector.



    A170012E01
  1. Connect the wiring harness protector. (w/ oil cooler)



2. INSPECT FOR OIL LEAK
  1. Start the engine.

  1. Check for engine oil leaks from the oil pressure switch assembly.



3. INSTALL FRONT FENDER APRON SEAL RH (for 4WD)


    A171853
  1. Install the front fender apron seal RH with the 2 bolts and clip.



4. INSTALL FRONT FENDER LINER RH (for 4WD)


5. INSTALL ENGINE UNDER COVER ASSEMBLY (for 2WD)


    A171850
  1. Install the engine under cover assembly with the 4 bolts and 5 clips.



    A171849
  1. Install the engine under cover assembly RR with the 2 bolts.



6. INSTALL FRONT WHEEL RH (for 4WD)

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }