Home › ENGINE › 2GR-FE LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH (for 4WD)


2. REMOVE ENGINE UNDER COVER ASSEMBLY (for 2WD)


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



3. DISCONNECT FRONT FENDER LINER RH (for 4WD)


4. REMOVE FRONT FENDER APRON SEAL RH (for 4WD)


    A171853
  1. Remove the 2 bolts, clip and front fender apron seal RH.



5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A170012E01
  1. Disconnect the wiring harness protector. (w/ oil cooler)

  1. Disconnect the oil pressure switch assembly connector.



    A127994
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch. (w/o oil cooler)



    A170011
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch. (w/ oil coole )