LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK ENGINE OIL LEVEL |
Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.
If the engine oil level is low, check for leakage and add oil up to the full level mark.
| 2. CHECK ENGINE OIL |
Check the engine oil for deterioration, water contamination, discoloring or thinning.
If the condition is visibly poor, replace the engine oil and engine oil filter.
| 3. REMOVE FRONT WHEEL RH (for 4WD) |
| 4. REMOVE ENGINE UNDER COVER ASSEMBLY (for 2WD) |
![]() |
Remove the 2 bolts and engine under cover assembly RR.
![]() |
Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.
| 5. DISCONNECT FRONT FENDER LINER RH (for 4WD) |
| 6. REMOVE FRONT FENDER APRON SEAL RH (for 4WD) |
![]() |
Remove the 2 bolts, clip and front fender apron seal RH.
| 7. CHECK OIL PRESSURE |
![]() |
Disconnect the wiring harness protector. (w/ oil cooler)
Disconnect the oil pressure switch assembly connector.
![]() |
Using a 24 mm deep socket wrench, remove the oil pressure switch. (w/o oil cooler)
![]() |
Using a 24 mm deep socket wrench, remove the oil pressure switch. (w/ oil cooler)
![]() |
Install the oil pressure gauge w/ adapter.
Warm up the engine.
Check the oil pressure.
| Engine Condition | Oil Pressure |
| Idle | 80 kPa (0.8 kgf/cm2, 11.6 psi) or more |
| 3000 rpm | 380 kPa (3.9 kgf/cm2, 55.1 psi) or more |
![]() |
Remove the oil pressure gauge.
Apply adhesive to 2 or 3 threads of the oil pressure switch.
![]() |
Using a 24 mm deep socket wrench, install the oil pressure switch. (w/o oil cooler)
![]() |
Using a 24 mm deep socket wrench, install the oil pressure switch. (w/ oil cooler)
Connect the oil pressure switch assembly connector.
![]() |
Connect the wiring harness protector. (w/ oil cooler)
Start the engine.
Check for engine oil leaks from the oil pressure switch assembly.
| 8. INSTALL FRONT FENDER APRON SEAL RH (for 4WD) |
![]() |
Install the front fender apron seal RH with the 2 bolts and clip.
| 9. INSTALL FRONT FENDER LINER RH (for 4WD) |
| 10. INSTALL ENGINE UNDER COVER ASSEMBLY (for 2WD) |
![]() |
Install the engine under cover assembly with the 4 bolts and 5 clips.
![]() |
Install the engine under cover assembly RR with the 2 bolts.
| 11. INSTALL FRONT WHEEL RH (for 4WD) |