Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER ASSEMBLY


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



2. REMOVE NO. 1 ENGINE UNDER COVER


    A171855
  1. Remove the 6 bolts, 2 clips and No. 1 engine under cover.



3. REMOVE NO. 2 ENGINE UNDER COVER


    A171854
  1. Remove the 2 bolts and No. 2 engine under cover.



4. REMOVE FRONT FLOOR COVER LH


    A171744
  1. Remove the 3 clamps, 6 bolts and front floor cover LH.



5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD)


    C166039
  1. Depress the brake pedal and hold it.

  1. Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.

    HINT:
    Put a piece of cloth or equivalent into the inside of the universal joint cover so that the boot does not touch the inside of the universal joint cover.



    C166040E01
  1. Place matchmarks on the rear propeller shaft and rear drive pinion flange sub-assembly.

  1. Remove the 4 nuts, 4 bolts and 4 washers.



    C166041
  1. Remove the 4 bolts and 4 adjusting shims.



    C166073
  1. Using a brass bar and a hammer, remove the propeller shaft with center bearing shaft assembly.



    C166042E01
  1. Insert SST into the transfer to prevent oil leakage.

    SST
    09325-20010  



6. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A170139
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.



7. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A170125
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

  1. Remove the gasket from the No. 3 exhaust pipe sub-assembly.



8. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY


    A171743
  1. Remove the 3 clamps and disconnect the heated oxygen sensor (for bank 1 sensor 2) connector.



    A170126
  1. Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.

  1. Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.



9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A171745
  1. Disconnect the heated oxygen sensor (for bank 2 sensor 2) connector.



    A170127
  1. Loosen the bolt.

  1. Remove the 2 nuts and front exhaust pipe assembly.

  1. Remove the gasket from the front exhaust pipe assembly.



10. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A172497E01
  1. Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.

    SST
    09224-00010  



11. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A172498E01
  1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

    SST
    09224-00010