Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › INTEGRATION RELAY

INTEGRATION RELAY > REMOVAL

for Preparation Click here



1. SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY


    A171831
  1. Disconnect the level warning switch connector.

  1. Remove the bolt, and separate the brake master cylinder reservoir assembly.



2. REMOVE RESERVOIR BRACKET


    A171859
  1. Remove the 2 bolts and reservoir bracket.



3. REMOVE NO. 1 RELAY BLOCK COVER


    A171748
  1. Remove the No. 1 relay block cover.



4. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY


    A171749
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and disconnect the engine room junction block assembly.



    A171750
  1. Disconnect the 4 connectors.