Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
  1. Disconnect the 1F, 1M and 1D junction block connectors.



  2. Disconnect the D8 and D10 main body ECU (instrument panel junction block) connectors.


    B139183E02

  3. Measure the resistance and voltage according to the value(s) in the table below.

    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1F-10 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1M-9 (GND2) - Body ground
    1D-10 (BECU) - Body ground
    W - Body ground
    Power source
    Always
    10 to 14 V
    D8-24 (DCTY) - Body ground
    G - Body ground
    Driver door courtesy light switch signal
    Switch pushed (Door closed)
    10 kΩ or higher
    Switch free (Door opened)
    Below 1 Ω
    D10-5 (KSW) - Body ground
    GR - Body ground
    Key unlock warning switch signal
    No key is in ignition key cylinder
    10 kΩ or higher
    Key is in ignition key cylinder
    Below 1 Ω

    HINT:
    If the result is not as specified, there may be a malfunction on the wire harness side.