Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B172745
  1. Remove the 11 clips and cool air intake duct seal.



2. REMOVE RADIATOR GRILLE


    B172749E01
  1. Put protective tape around the radiator grille.



    B172746
  1. Remove the 2 bolts and 4 clips.



    B172747
  1. Disengage the 6 claws and 4 guides, and remove the radiator grille.



3. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)


    B172760E01
  1. Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172761E01
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172763
  1. Remove the 7 screws and clip.



    B172764
  1. Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.



4. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)


    B172760E01
  1. Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172761E01
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172763
  1. Remove the 7 screws and clip.



    B172764
  1. Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each fog light connector, and then remove the front bumper assembly.



5. REMOVE REAR FENDER SPLASH SHIELD SUB-ASSEMBLY


    E150040
  1. Disengage the 3 clips and 3 guides, and remove the rear fender splash shield sub-assembly.



6. REMOVE HEADLIGHT ASSEMBLY


    E150041
  1. Remove the bolt and 2 screws.

  1. Disengage the claw and disconnect the headlight assembly.



    E150042
  1. Disengage the clamp.

  1. Disconnect the connectors and remove the headlight assembly.