Home › BODY › EXTERIOR › FENDER LINER (for Rear Side)

FENDER LINER (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR WHEEL HOUSE LINER LH


    B174758
  1. Install the rear wheel house liner LH with the 10 clips.



2. INSTALL REAR WHEEL HOUSE LINER RH


    B174759
  1. Install the rear wheel house liner RH with the 10 clips.



3. INSTALL REAR BUMPER SIDE SEAL LH


    B174757
  1. Install 2 new grommets.

  1. Install the rear bumper side seal LH with the clip, bolt and screw.



4. INSTALL REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedures for the RH side and LH side.



5. INSTALL QUARTER PANEL SEAL LH

HINT:
When installing a new quarter panel seal, heat the vehicle body and quarter panel seal using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Quarter Panel Seal
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or quarter panel seal excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove any double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.



    B174756E01
  1. Install a new quarter panel seal LH.

    1. Using a heat light, heat the vehicle body and a new quarter panel seal LH.

    2. Remove the release paper from the quarter panel seal LH.

      HINT:
      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. Install the quarter panel seal LH with the 4 screws.



6. INSTALL QUARTER PANEL SEAL RH

HINT:
Use the same procedures for the RH side and LH side.



7. INSTALL REAR WHEEL HOUSE PAD LH


    B174755
  1. Install the rear wheel house pad LH with the 3 screws.



8. INSTALL REAR WHEEL HOUSE PAD RH

HINT:
Use the same procedure for the RH side and LH side.